Kitchen Cabinet Installation - Gilbert
Gilbert, AZ
Project Overview
Problem / before: The kitchen was being redone and needed the old cabinets, countertops, and appliances removed before new storage could be assembled and installed. The cabinets had to be level and secure so another vendor could install the quartz countertops.
Work completed: Existing cabinets, countertops, and appliances were removed. RTA cabinets purchased from Home Depot were assembled and installed, with cabinets secured to the walls using cabinet screws. The face frames were connected side to side to create a more secure cabinet run. After the countertop was installed by another vendor, the undermount sink, faucet, soap dispenser, and RO water system were added.
Result: The kitchen gained a clean, level cabinet layout that was ready for countertop installation and final fixture details.
Scope of Work
- Removed existing cabinets, countertops, and appliances
- Assembled RTA kitchen cabinets
- Installed and leveled cabinets for quartz countertop installation by another vendor
- Secured cabinets to wall framing with cabinet screws
- Connected cabinet face frames side to side for a secure run
- Added undermount sink, faucet, soap dispenser, and RO water system after countertop install
Customer Benefit
Cabinet work depends on careful layout, anchoring, leveling, and alignment. This project shows the detail needed before countertops and finish fixtures can be installed correctly.
Scope Note
This project is shown as personal-project proof of cabinet installation skill. A full kitchen cabinet installation would usually be outside the normal launch scope because of the Arizona handyman exemption threshold. Current public service offers should stay focused on cabinet pulls, hinges, alignment, small drawer/slide fixes, and smaller punch-list cabinet support unless a larger project is separately reviewed.
SEO / AEO Notes
For search and AI-answer usefulness, this page should make the limits clear: it demonstrates cabinet assembly, anchoring, leveling, face-frame alignment, and coordination with countertop installation, but it should not imply that full kitchen remodels are a standard launch offer.
Proof Bucket
cabinets, trim_finish, before_after, proof_only_larger_project
Project Gallery
Project Details
Category
Punch Lists & Make-Ready
Location
Gilbert, AZ
Completed
April 2026
Need Similar Work Done?
Get a free quote for your punch lists & make-ready project today!
More Punch Lists & Make-Ready Projects
Custom Outdoor Planter Bed - Gilbert
Gilbert custom cedar planter bed build with movable 45 x 18 x 18 inch food-safe cedar construction, drainage holes, and patio garden flexibility.
Gilbert, AZ
Custom Bookshelf Built-In - Mesa
Mesa custom bookshelf built-in proof with plywood and MDF construction, sprayed cabinet finish, and fit constraints around doors and an air vent.
Mesa, AZ